Replace the control board with a proper part number and or hardware revision If the alarm does not clear, log into the Technical Support Website at html for more information or call Cisco TAC (1 800 553-2447). Customers in the use of optical modules will more or less encounter a variety of failure problems, such as optical module model selection is correct, the use of jumper is correct and some common problems, customers have the ability to judge and have a clear solution, but for some of the use of. This chapter gives a description, severity, and troubleshooting procedure for each commonly encountered Cisco NCS 1001 alarm and condition. When an alarm is raised, refer to its clearing procedure. Default Severity: Critical (CR), Service Affecting (SA) Logical Object: EQUIPMENT The 0/PM [0|1] Unit. Run the display interface transceiver command on the switch to check whether any alarm information has been generated for the optical module. Removing and reinstalling the optical module. The optical module on the port generates an alarm. View the diagnostic information display logbuffer and find that the interface has multiple alarms and has been fluctuating.
[PDF Version]